Juniper Networks ERX Hardware 8 - Manual (Page 95)

Chapter 7
Accessing ERX Routers
This chapter discusses how to access the system to manage it. Managing your
router includes both configuring and monitoring it. For basic information on
the management of the system, see JUNOSe System Basics Configuration Guide,
Chapter 5, Managing the System.
This chapter contains the following sections:
Setting Up Management Access on page 77
Console Port Setup on page 78
Telnet Setup on page 80
SNMP on page 82
The Next Step on page 82
Setting Up Management Access
Before you power up the system, you must set up a management console.
(See “Connecting to a Console Terminal” on page 60.) You use the console to
communicate with the system during the power-up process, set an IP address,
and manage the system using the command-line interface (CLI).
You can manage and monitor the router through either of these methods:
Console terminal—Connect a console (PC, Macintosh, or UNIX workstation)
directly to the system’s RS-232 serial port.
Remote console—Connect the 10/100Base-T port on the SRP I/O module to an
Ethernet network, and run Telnet from a remote console.
For initial access to the system, you need to physically connect your console
directly to the system’s RS-232 port. Through this connection you can use the
CLI to set an IP address on the system. After you configure the IP address,
you can access the system remotely (for example, via Telnet).
Setting Up Management Access 77