Seiko Group OC CS 6060 IP-6600 - Manual (Page 18)

CONTENTS-2
Section 2 Basic Operations
Connecting with Computer .............................................................. 2-2
System configuration (connection example) ....................... 2-2
Connection procedure ......................................................... 2-2
Turning the Power On/Off ................................................................ 2-5
Turning the Power On ......................................................... 2-6
Turning the Power Off ......................................................... 2-9
Replacing the Paper Roll ............................................................... 2-11
Installing Paper Roll in the Printer ..................................... 2-11
Removing the Paper Roll from the Printer ......................... 2-17
Replacing Paper Roll with Another .................................... 2-18
Replacing Empty Paper Roll ............................................. 2-18
Replacing Jammed Paper Roll .......................................... 2-18
Installing/Removing Cut Sheet in/from the Printer ............ 2-19
Replacing Ink Cartridges ............................................................... 2-20
Ink Cartridge Replacement Procedure .............................. 2-20
Replacing Empty Ink Cartridge .......................................... 2-22
If an Ink Cartridge Is Not Installed ..................................... 2-23
If an Ink Cartridge Is Not Detected .................................... 2-24
Replacing the Waste Ink Bottle ...................................................... 2-25
Waste Ink Bottle Replacement Procedure ........................ 2-25
If the Waste Ink Bottle Is Full ............................................. 2-27
If the Waste Ink Bottle Is Not Installed .............................. 2-28
Head Cleaning "CLEANING" ......................................................... 2-29
Paper Feed "FEED" ....................................................................... 2-31
Using the Origin Point Setting Function ............................ 2-32
Installing Paper on Winder ............................................................. 2-35
Changing Heater Control Setting Temperature ............................. 2-40
Using the Media Pressure Alternation Lever ................................. 2-42
Using the Head Up/Down Lever .................................................... 2-43
Using the Media Edge Guard ........................................................ 2-45