Seiko Group OC CS 6060 IP-6600 - Manual (Page 69)

2-25
Section 2 Basic Operations
Replacing the Waste Ink Bottle
This section describes how to replace a waste ink bottle.
The waste ink bottle should be replaced in the following two cases:
- If the waste ink bottle is full
- If the waste ink bottle is not installed
The waste ink bottle replacement procedures for these cases are
explained below.
-Do not replace the waste ink bottle during printing.
Waste Ink Bottle Replacement Procedure
1
Loosen the knob and lift up the lever from the waste ink
bottle.
2
Wait for a while to drop the remaining ink into the ink tub.
3
Take out the filled waste ink bottle from the printer, and
securely cap the waste ink bottle to replace with a new
one.
Waste ink bottle
NOTE
(1)
(2)
(3)
Lever
Knob
Tube