Seiko Group OC CS 6060 IP-6600 - Manual (Page 47)

2-3
Section 2 Basic Operations
3
Set the ID switch on the rear of the printer.
- The ID number must not be unique in the SCSI chain. (Initial
setting: 4)
SCSI connector
NOTE
- Use a dedicated SCSI cable (68-68-pin, 6 m).
If using a cable except the specified one, the printer can
not satisfy FCC and CE regulations.
ID switch
Set the ID number with a small normal
driver, etc. (Initial ID value: 4)
2
Connect a SCSI cable to a SCSI connector on the rear of
the printer.
(It can be connected to any one of two SCSI connectors.)
Connecting with Computer
NOTE