Seiko Group OC CS 6060 IP-6600 - Manual (Page 83)

2-39
Section 2 Basic Operations
- Slacken the paper so that it passes inside the winding
sensor.
- If the winding unit is not used, turn the winding unit switch
off.
- When the paper roll for the winding unit nears the diameter
of the winding unit’s flange, remove the winding side paper
roll and replace the paper tube with a new one.
If not so, a winding error may occur.
NOTE
- When printing without using a winding unit, edge of paper
or printing surface may be damaged or be folded due to
contact with the winding sensor caused by winds.
In case that the paper roll for the winding
unit exceeds the diameter of the winding
unit’s flange.
Outer winding
Winding unit OFF
•
Winding unit switch setting
Either internal winding or external winding can be selected.
When the winding unit is not used, turn the winding unit switch
off.
Inner winding
Installing Paper on Winder