Sharp AR-5316 - Manual (Page 16)

14
BEFORE USING THE MACHINE
LOADING PAPER
Make sure that the machine is not copying or printing, and then follow these steps to load paper.
Loading the paper tray
1 Gently lift and pull out the paper tray
until it stops.
2 Push the pressure plate down until it
locks in place.
Push the center of the
pressure plate down until
it locks into place.
3 Fan the paper.
If the paper is not fanned,
double-feeds or misfeeds
may occur.
4 Load paper into the tray.
5 Gently push the paper tray into the
machine.
15
• Do not load paper higher than the line on
the tray (up to 250 sheets).
• Make sure that the paper fits under the tabs
on the right side of the tray.
• Make sure the stack of paper is straight
before loading it. When adding paper, take
the remaining paper out and combine it into
a single stack with the new paper.
Note
If you loaded a different size of paper than
was loaded previously in the tray, go to
"CHANGING A TRAY’S PAPER SIZE
SETTING" (p.16).
Note
AR-5316-5320-EX.book 14 ページ ２００５年４月８日 金曜日 午前９時３５分