Sharp AR-5316 - Manual (Page 22)

20
COPY FUNCTIONS
Removing the document cover
To copy large originals like newspapers, remove the
document cover. To remove the cover, lift straight
up as shown. To replace the cover, do the reverse.
The SPF cannot be removed.
Copying books or originals with folds or
creases
Press down on the document cover/SPF while
copying as shown. If the document cover/SPF is not
completely closed, shadows may appear on the
copy or it may be fuzzy. Straighten originals with
folds or creases well before placing.
Originals that can be used in the SPF
Originals that are 5-1/2" x 8-1/2" to 11" x 17" and 15
lbs. to 24 lbs. (56 g/m
2
to 90 g/m
2
) can be used. A
maximum of 40 pages can be placed at once.
For originals that are 8-1/2" x 14" or larger (8-1/2" x
14", 11" x 17"), a maximum of 30 pages can be
placed at once.
Originals that cannot be used in the SPF
The following originals cannot be used. These may
cause misfeeds or smudging and unclear images.
• Transparencies, tracing paper, other transparent or
translucent paper, and photographs.
• Carbon paper, thermal paper.
• Originals that are creased, folded, or torn.
• Glued originals, cut-out originals.
• Originals with binder holes.
• Originals printed using an ink ribbon (thermal
transfer printing), originals on thermal transfer
paper.
Stream feeding mode
If "Stream feeding mode" is enabled in the user
programs (p.33), the SPF indicator will blink for
about 5 seconds after all originals are fed. If a new
original is placed in the SPF during this time, the
original will be automatically fed in and copying will
begin.
• Make sure that there are no paper clips or
staples on the original.
• Straighten curled originals before placing
them in the document feeder tray. Curled
originals may cause misfeeds.
Note
!Chapter2.fm 20 ページ ２００５年４月８日 金曜日 午後２時０分