Sharp AR-5316 - Manual (Page 25)

23
COPY FUNCTIONS
2
4 Press the [AUTO IMAGE] key.
The AUTO IMAGE
indicator lights up and the
appropriate ratio for the
original size and paper
size is selected. (The
indicator of the selected
ratio will light up.)
5 Set the number of copies and other
copy settings, and then press the
[START] key (
).
The copy will be delivered to the paper output
tray.
MANUAL RATIO SELECTION
Copies can be reduced down to 25% or enlarged up to 400%. The [PRESET RATIO] selector keys ( , ) can be
pressed to quickly select a ratio from among eight preset ratios. In addition, the [Zoom] keys ( , ) can be
pressed to select the ratio in increments of 1%.
1 Place the original(s) in the document
feeder tray or on the document glass.
2 If the original is placed on the document
glass, select the original size. (p.18)
3 Use the [PRESET RATIO] selector
keys (
, ) and [Zoom] keys ( , )
to select the desired copy ratio.
Selecting a preset ratio
Press the [PRESET
RATIO] selector key (
)
to move up through the
preset ratios.
Press the [PRESET
RATIO] selector key (
)
to move down through
the preset ratios.
Fine adjustment of the
ratio
Any ratio from 25% to
400% can be set in
increments of 1%.
Press a [PRESET RATIO] selector key ( or ) to
set the approximate ratio, then press the [Zoom] keys
(
or ) to increase or decrease the ratio.
To decrease or increase the zoom ratio rapidly, hold
down the [Zoom] keys (
or ).
When a [Zoom] key ( or ) is pressed, the ZOOM
indicator will light up and the zoom ratio will appear in
the display for about two seconds.
4 Set the number of copies and other
copy settings, and then press the
[START] key (
).
The copy will be delivered to the paper output
tray.
• If the ORIGINAL SIZE indicator blinks,
change the orientation of the placed original.
• If the copy is made when a PRESET
RATIO selector indicator is blinking, the
copied image may run off the page.
AUTO
IMAGE
Note
To cancel automatic ratio selection, press the
[AUTO IMAGE] key again. Note
PRESET RATIO
200%
100%
50%
141
95
77
64
129
121
25 400% ZOOM
• To verify a zoom setting without changing
the zoom ratio, Hold down the [Copy ratio
display] key (
). When the key is
released, the display will return to the
number of copies display.
• If the copy is made when a PRESET
RATIO selector indicator or the ZOOM
indicator is blinking, the copied image may
run off the page. To ensure that the image
fits on the page, lower the copy ratio until
the indicator stops blinking and lights
steadily.
• If the PAPER SIZE indicator is not lit, there
is no appropriate paper. Load appropriate
paper in a paper tray. (p.14)
To return the ratio to 100%, press the
[PRESET RATIO] selector key (
or )
until the 100% indicator lights up.
Note
Note
AR-5316-5320-EX.book 23 ページ ２００５年４月８日 金曜日 午前９時３５分