Sharp AR-5316 - Manual (Page 28)

26
TWO-SIDED COPYING USING THE
BYPASS TRAY
To perform manual two-sided copying, follow these steps.
Example: Copying originals A and B onto each side of one sheet of paper
1 Copy original A.
2 Place original B as shown below.
Vertically-oriented
original:
If the original is oriented
vertically, place it in the
same orientation as
original A.
Horizontally-oriented
original:
If the original is oriented
horizontally, place it with
the top and bottom and
left and right sides
reversed with respect to
the placement of original
A.
3 Turn the copy of original A over, and
without changing the position of the
edge closest to you, insert it in the
bypass tray.
Insert the paper all the
way in.
4 Select the bypass tray with the [TRAY
SELECT] key (
), and then press the
[START] key ( ).
The copy is delivered to the paper output tray.
1 2 1
Original A Original B Copy
1 1
Original A Copied original A
1 1
Original A Copied original A
2
Original B
2
Original B
• Copies made on the back side of paper
should always be made one sheet at a time
using the bypass tray.
• Straighten curled or wavy paper before
using it. Curled paper may cause misfeeds,
creases, or a poor-quality image.
2 1 1
Original B
Copied
original A
2
1 1
Original B
Copied
original A
Note
AR-5316-5320-EX.book 26 ページ ２００５年４月８日 金曜日 午前９時３５分