Samsung S3C2440A - Manual (Page 66)

S3C2440A RISC MICROPROCESSOR ARM INSTRUCTION SET
3-9
DATA PROCESSING
The data processing instruction is only executed if the condition is true. The conditions are defined in Table 3-2.
The instruction encoding is shown in Figure 3-4.
31 24 27 19 15
Cond Operand2
28 16 11 12 21
[15:12] Destination register
0 = Branch 1 = Branch with link
[19:16] 1st operand register
0 = Branch 1 = Branch with link
[20] Set condition codes
0 = Do not after condition codes 1 = Set condition codes
[24:21] Operation codes
0000 = AND-Rd: = Op1 AND Op2
0001 = EOR-Rd: = Op1 EOR Op2
0010 = SUB-Rd: = Op1-Op2
0011 = RSB-Rd: = Op2-Op1
0100 = ADD-Rd: = Op1+Op2
0101 = ADC-Rd: = Op1+Op2+C
0110 = SBC-Rd: = OP1-Op2+C-1
0111 = RSC-Rd: = Op2-Op1+C-1
1000 = TST-set condition codes on Op1 AND Op2
1001 = TEO-set condition codes on OP1 EOR Op2
1010 = CMP-set condition codes on Op1-Op2
1011 = SMN-set condition codes on Op1+Op2
1100 = ORR-Rd: = Op1 OR Op2
1101 = MOV-Rd: =Op2
1110 = BIC-Rd: = Op1 AND NOT Op2
1111 = MVN-Rd: = NOT Op2
[25] Immediate operand
0 = Operand 2 is a register 1 = Operand 2 is an immediate value
[11:0] Operand 2 type selection
26 25
00 L
20
OpCode S Rn Rd
0
Rotate
Shift Rm
[3:0] 2nd operand register [11:4] Shift applied to Rm
3 11 0 4
8 11 0 7
Imm
[7:0] Unsigned 8 bit immediate value [11:8] Shift applied to Imm
[31:28] Condition field
Figure 3-4. Data Processing Instructions