Node, Unloading llt and gab and, Removing vcs on the departing node – Symantec Veritas 5 User Manual
Page 137
Unloading LLT and GAB and removing VCS on the departing node
Perform the tasks on the node that is departing the cluster.
If you have configured VCS as part of the Storage Foundation and High Availability
products, you may have to delete other dependent RPMs before you can delete all
of the following ones.
To stop LLT and GAB and remove VCS
1
If you had configured I/O fencing in enabled mode, then stop I/O fencing.
#
/etc/init.d/vxfen stop
2
Stop GAB and LLT:
#
/etc/init.d/gab stop
#
/etc/init.d/llt stop
3
To determine the RPMs to remove, enter:
#
rpm -qa | grep VRTS
4
To permanently remove the VCS RPMs from the system, use the
rpm -e
command. Start by removing the following RPMs, which may have been
optionally installed, in the order shown:
#
rpm -e VRTScmccc
#
rpm -e VRTScmcs
#
rpm -e VRTScssim
#
rpm -e VRTScscm
#
rpm -e VRTSvcsmn
#
rpm -e VRTScutil
#
rpm -e VRTSweb
#
rpm -e VRTScscw
#
rpm -e VRTSjre15
#
rpm -e VRTSjre
#
rpm -e VRTSvcsdr
#
rpm -e VRTSvcsag
#
rpm -e VRTSacclib
#
rpm -e VRTSvcsmg
#
rpm -e VRTSvcs
#
rpm -e VRTSvxfen
#
rpm -e VRTSgab
#
rpm -e VRTSllt
137
Adding and removing cluster nodes
Removing a node from a cluster