Symantec Veritas 5 - Manual (Page 33)

Installing the root broker for the security infrastructure
Install the root broker only if you plan to use AT to configure the cluster in secure
mode. The root broker administrator must install and configure the root broker
before you configure the Authentication Service for VCS. Symantec recommends
that you install the root broker on a stable system that is outside the cluster.
You can install the root broker on an AIX, HP-UX, Linux, or Solaris system.
See Symantec Product Authentication Service documentation for more
information.
See “About Symantec Product Authentication Service (AT)” on page 19.
To install the root broker
1 Change to the directory where you can start the Veritas product installer:
# ./installer
2 From the opening Selection Menu, choose: I for "Install/Upgrade a Product."
3 From the displayed list of products to install, choose: Symantec Product
Authentication Service.
4 To install the root broker, select the mode of AT installation as root mode
from the three choices that the installer presents:
1)Root+AB Mode
2)Root Mode
3)AB Mode
Enter the mode which you would like AT installed? [1-3,q] 2
5 Enter the name of the system where you want to install the root broker.
Enter the system name on which to install AT: venus
6 Review the output as the installer does the following:
■ Checks to make sure that VCS supports the operating system
■ Checks if the system is already configured for security
7 Review the output as the installer checks for the installed RPMs on the system.
The installer lists the RPMs that the program is about to install on the system.
Press Enter to continue.
8 Review the output as the installer installs the root broker on the system.
33 Preparing to install VCS
Preparing to configure the clusters in secure mode