Symantec Veritas 5 - Manual (Page 155)

3 Enter the names of the systems from which you want to uninstall VCS.
The program performs system verification checks and asks to stop all running
VCS processes.
4 Enter y to stop all the VCS processes.
The program proceeds with uninstalling the software.
5 Answer the prompt to proceed with uninstalling the software.
Select one of the following:
■ To uninstall VCS on all nodes, press
Enter
.
■ To uninstall VCS only on specific nodes, enter
n
.
Do you want to uninstall VCS from these systems? [y,n,q] (y)
6 If the uninstallvcs program prompts, enter a list of nodes from which you
want to uninstall VCS.
The uninstallvcs program prompts this information in one of the following
conditions:
■ You enter n .
■ The program finds no VCS configuration files on the local node.
7 If RPMs, such as enterprise agents, are found to be dependent on a VCS RPM,
the uninstaller prompt you on whether you want them removed. Enter
y
to
remove the designated RPMs.
8 Review the uninstaller report after the verification.
9 Press Enter to uninstall the VCS RPMs.
Are you sure you want to uninstall VCS rpms? [y,n,q] (y)
10 Review the output as the uninstaller stops processes, unloads kernel modules,
and removes the RPMs.
11 Note the location of summary and log files that the uninstaller creates after
removing all the RPMs.
Running uninstallvcs from the VCS 5.0 RU3 disc
You may need to use the uninstallvcs program on the VCS 5.0 RU3 disc in one of
the following cases:
■ You need to uninstall VCS after an incomplete installation.
155 Uninstalling VCS
Uninstalling VCS 5.0 RU3