Symantec Veritas 5 - Manual (Page 145)

To install and configure Ethernet cards for private network
1 Shut down VCS on Node A.
# hastop -local
2 Shut down the node to get to the OK prompt:
# shutdown -r now
3 Install the Ethernet card on Node A.
If you want to use aggregated interface to set up private network, configure
aggregated interface.
4 Install the Ethernet card on Node B.
If you want to use aggregated interface to set up private network, configure
aggregated interface.
5 Configure the Ethernet card on both nodes.
6 Make the two Ethernet cable connections from Node A to Node B for the
private networks.
7 Restart the nodes.
Configuring the shared storage
Make the connection to shared storage from Node B. Configure VxVM on Node B
and reboot the node when you are prompted.
See “Setting up shared storage” on page 46.
Bringing up the existing node
Bring up the node.
To bring up the node
1 Restart Node A.
2 Log in as superuser.
3 Make the VCS configuration writable.
# haconf -makerw
4 Display the service groups currently configured.
# hagrp -list
145 Installing VCS on a single node
Adding a node to a single-node cluster