Symantec Veritas 5 - Manual (Page 69)

5 Choose whether to use the same NIC details to configure private heartbeat
links on other systems.
Are you using the same NICs for private heartbeat links on all
systems? [y,n,q,b,?] (y)
If you want to use the NIC details that you entered for galaxy, make sure the
same NICs are available on each system. Then, enter
y
at the prompt.
If the NIC device names are different on some of the systems, enter
n
. Provide
the NIC details for each system as the program prompts.
6 Verify and confirm the information that the installer summarizes.
Configuring the cluster in secure mode
If you want to configure the cluster in secure mode, make sure that you meet the
prerequisites for secure cluster configuration.
The installvcs program provides different configuration modes to configure a
secure cluster. Make sure that you completed the pre-configuration tasks for the
configuration mode that you want to choose.
See “Preparing to configure the clusters in secure mode” on page 29.
To configure the cluster in secure mode
1 Choose whether to configure VCS to use Symantec Product Authentication
Service.
Would you like to configure VCS to use Symantec Security
Services? [y,n,q] (n) y
■ If you want to configure the cluster in secure mode, make sure you meet
the prerequisites and enter
y
.
■ If you do not want to configure the cluster in secure mode, enter
n
.
You must add VCS users when the configuration program prompts.
See “Adding VCS users” on page 71.
2 Select one of the options to enable security.
Select the Security option you would like to perform [1-3,q,?]
Review the following configuration modes. Based on the configuration that
you want to use, enter one of the following values:
69 Installing and configuring VCS
Installing and configuring VCS 5.0 RU3