Symantec Veritas 5 - Manual (Page 44)

collisions:0 txqueuelen:1000
RX bytes:35401016 (33.7 Mb) TX bytes:999899 (976.4 Kb)
Base address:0xdce0 Memory:fcf20000-fcf40000
If a file named etc/sysconfig/network/ifcfg-eth-id-00:02:B3:DB:38:FE does
not exist, do the following task:
■ Create the file.
■ If the file /etc/sysconfig/network/ifcfg-eth0 exists, then copy the contents
of this file into etc/sysconfig/network/ifcfg-eth-id-00:02:B3:DB:38:FE.
Add the following to the end of the file named
etc/sysconfig/network/ifcfg-eth-id-00:02:B3:DB:38:FE,
PERSISTENT_NAME=eth0
Perform the procedure for all the interfaces that the
ifconfig -a
command
displays.
To configure interfaces to be up before starting LLT
1 For each network interface that you want LLT to use, find its MAC address
by running the
ifconfig command:
# ifconfig eth0
eth0 Link encap:Ethernet HWaddr 00:0C:0D:08:C4:32
Where
eth0
is the sample network interface name. The output displays
00:0C:0D:08:C4:32 as the interface’s MAC address.
2 Navigate to the config file in the /etc/sysconfig/network directory:
# cd /etc/sysconfig/network
3 Open the config file in an editor.
4 Append the string eth-id-macaddress to the MANDATORY_DEVICES list in
the config file. Separate each address with a space, for example:
MANDATORY_DEVICES="eth-id-00:0C:0D:08:C4:31
eth-id-00:0C:0D:08:C4:32"
Setting up inter-system communication
When you install VCS using the installvcs program, to install and configure the
entire cluster at one time, make sure that communication between systems exists.
By default the installer uses ssh. You must grant root privileges for the system
Preparing to install VCS
Performing preinstallation tasks 44