Sierra Monitor Corporation HRG015-W - Manual (Page 29)

HRX-OM-J049-A
Chapter 3 Transport and Installation
HRG010-W HRG015-W 3.2 Installation
1st edition : Aug. 2006
Rev. A: May. 2007
3-7
3.2.4 Installation
z Keep the unit away from vibration. Install the unit on a flat and stable surface.
z Refer to “7.3 Outline Dimensions” for the dimensions of the unit.
„ Procedure for Installation
1.
The anchor bolts (foundation bolts) are mounted on the level concrete foundation.
Lower this unit, inserting the anchor bolts into the unit.
2.
Tighten the hexagonal nut to secure the unit onto the foundation.
3.
Make sure of no looseness between the anchor bolts and foundation.
Fig. 3-5 Procedure for Installation
Anchor bolt mounting hole (Ø13)
Concrete foundation
Front
Anchor bolt
Hexagonal nut
Base
Preparation of anchor bolts suitable for floor material is your
responsibility.
Prepare M12-anchor bolts (4 pcs.) for installation. See “ 7.3 Outline
Dimensions” for mounting of the anchor bolts.