Sony XDCAM HD PDW-HD1500 User Manual
Page 109
109
Setup Menu
Chap
te
r 7
Men
u
s
a) When the separately sold PDBK-S1500 option is installed.
b) When the separately sold PDBK-201 option board is installed
c) FTP connections can be made only when the device connected to the
REMOTE(9P) connector (D-sub 9 pin) is in stop mode. During FTP
connections, the device connected to the REMOTE(9P) connector cannot
be used to control this unit.
214
REMOTE INTERFACE
When the remote control switch is set to REMOTE, select the device from
which to remote-control this unit.
9PIN: Device connected to the REMOTE(9P) connector.
SDI: Device connected to the SD/HDSDI INPUT connector.
i.LINK: Device connected to the (i.LINK) S400 connector.
215
i.LINK MODE
b)
Select the connection method for the (i.LINK) S400 connector.
FAM (FAM (PC REMOTE)): FAM connection
TS: TS connection
257
NETWORK ENABLE
Select the remote control switch positions which enable network
connections.
net (network): Only when the switch is set to “NET”.
n&9P (network & remote(9PIN)): When the switch is set to “NET”, and
when the switch is set to “REMOTE” and setup menu item 214 is set
to “9PIN”.
c)
Menu items in the 200s, relating to the remote control interface
Item number
Item name
Settings
Menu items in the 300s, relating to editing operations
Item number Item name
Settings
301
VAR SPEED RANGE FOR
SYNCHRONIZATION
Select the playback speed range when carrying out playback in variable
speed mode from a remote control unit connected to the REMOTE(9P)
connector.
–2~+2: –2 to +2 times normal speed.
wide: –2.20 to +2.20 times normal speed.
320
DIGITAL AUDIO PB PROCESS ON
EDIT POINT
Select the treatment of audio playback at edit points.
cut: Carry out a cut (possibly resulting in audio discontinuities at the edit
point).
fade: Fade out and fade in.
344
ASSEMBLE AUTO EDIT
POSTROLL RECORDING
Set whether to record 2 seconds of postroll when an additional clip is
recorded by sending the AUTO EDIT command (9-pin protocol 20·42)
from a nonlinear editing system connected to the REMOTE(9P)
connector on the rear panel.
Note
When using a linear editing system, postroll will not be recorded
regardless of this setting.
off: Do not record postroll.
on: Records approximately 2 seconds of postroll.
Menu items in the 400s, relating to preroll
Item number Item name
Settings
401
FUNCTION MODE AFTER CUE-UP Select the state that the unit goes into after a cuing-up operation.
stop: Stops (the stop mode).
still: Still playback (in jog and shuttle mode).
Menu items in the 500s, relating to disc protection
Item number Item name
Settings
501
STILL TIMER
To protect the disc against shock and vibrations, and to lengthen the life
of the laser diodes, the unit automatically enters standby off mode
whenever a specified time elapses in a disc stop mode (stop mode or the
still picture mode of search mode). This allows you to set the time after
which the unit exits a disc stop mode and enters standby off mode.
0.5 s (0.5 sec)... 8 m (8 min)... 30 m (30 min): Can be set in the range
from 0.5 seconds to 30 minutes.
off: Do not put into standby off mode.