Sony XDCAM HD PDW-HD1500 User Manual
Page 138
138
Troubleshooting
App
end
ix
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
“on”.
Alarms relating to sensors and drives
Alarms related to system frequency and recording format
The following alarms are displayed only when setup menu
item 016 ALARM DISPLAY is set to “on” or “limit”.
REF NON-STD
A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO. USE A
STANDARD SIGNAL.
Input a standard signal.
Alarm message in time
data display area
Alarm message in video monitor screen Action
Alarm message in time
data display area
Alarm message in video monitor acreen Description/action
FAN Stopped
FAN MOTOR STOPPED.
Contact a Sony service representative.
Note
The unit will not stop operating, but if you continue to
use it in this state temperatures inside the unit or the
drive will rise, possibly resulting in failure or fire.
DR-FAN Stop
DRIVE FAN MOTOR STOPPED.
N-FAN Stop
FAN MOTOR ON NET-4 BOARD
STOPPED.
High TEMP!
HIGH TEMPERATURE.
HIGH TEMPERATURE IN DRIVE.
HIGH TEMPERATURE ON NET-4 BOARD.
HUMID!
MOISTURE HAS BEEN DETECTED.
Stop recording or playback, power the unit off and on
again, and wait until the HUMID display disappears.
BATT EMPTY!
BATTERY EMPTY!
Change the battery.
Unknown USB
UNKNOWN USB DEVICE.
The USB connector of this unit is for maintenance
purposes and connection of USB devices. Connect a
compatible USB device.
Alarm message in time
data display area
Alarm message in video monitor screen Action
1080/59.94i
RECORDING AND PLAYBACK IS NOT
POSSIBLE.
SYSTEM FREQUENCY SELECTION
DIFFER FROM IT ON DISC.
This appears when the system frequency selection of
the unit differs from that of the loaded disc.Insert a
disc with the same system frequency as the unit, or
change the unit’s system frequency.
1080/29.97P
1080/50i
1080/25P
720/59.94P
720/50P
525/59.94i
625/50i
1080/59.94i
DISC CANNOT BE RECORDED.
VIDEO RESOLUTION DIFFER FROM IT
ON DISC.
This appears when the number of system lines set in
this unit does not correspond to the resolution for the
inserted disc.
Change the disc to the one corresponding to the
number of system lines set in this unit or change the
number of system lines of this unit.
1080/50i
1080/29.97P
1080/25P
720/59.94P
720/50P