Sony XDCAM HD PDW-HD1500 - Manual (Page 89)

89
File Operations in File Access Mode (for Windows)
Cha
p
te
r 6
F
ile
O
per
a
tio
ns
6
Turn the PUSH SET(S.SEL) knob to move the “*” to
the left of “AUTO NAMING”, and press the knob.
7
Turn the PUSH SET(S.SEL) knob to select “title”, and
press the knob.
8
Press the SAVE function (F5) button.
The same name will now be given to newly recorded
clips.
To use clips and clip lists with user-defined
names over FAM and FTP connections
Carry out steps 2 to 5 of “To assign clip names on this
unit”, and then press the SAVE function (F5) button.
It is now possible to write, transfer, and rename clips and
clip lists with user-defined names over file access mode
(FAM) connections (page 89) and FTP connections
(page 93).
To check clip names
Press the THUMBNAIL button to display the thumbnail
screen, and select the clip whose name you want to check.
The name of the selected clip appears at the upper left of
the screen.
See “Thumbnail Operations” (page 64) for more
information about the thumbnail screen.
The item at the upper left of the screen is displayed
according to the following order of priority.
Title >User-defined clip name >Standard format clip name
Therefore, the display of this item changes as following,
depending on whether there is a title.
- When a title has been set as a clip name on this unit, for
clips recorded on this unit, the title is displayed.
- The user-defined name or standard format name is
displayed for clips without a title.
File Operations in File
Access Mode (for
Windows)
File access mode operating environment
Operating system requirements for file operations by file
access mode (called FAM below) are as follows.
• Computer operating system: Microsoft Windows XP
Professional SP2 or later, or Microsoft Windows Vista
Ultimate/Business (32-bit)
64-bit editions of Windows Vista are not supported.
Preparations
Install the FAM driver on the remote computer (see the
next section).
To install the FAM driver
Insert the supplied CD-ROM (XDCAM Application
Software) into the CD-ROM drive of your computer,
navigate to the FAM Driver directory, and run the installer
in the directory for your operating system, then follow the
installation instructions.
For details, refer to the ReadMe file contained on the CD-
ROM disc.
Use Version 2.10 or higher of the FAM driver. The FAM
driver on the supplied CD-ROM is Version 2.10 or higher.
If a FAM driver is already installed on your computer,
check the version.
To check the version
On Windows XP
Select “ProDisc” from “Add or Remove Programs” in the
control panel, and then click “Click here for support
information”.
On Windows Vista
(1) Open “Programs” >“Programs and Functions” in the
control panel, and then right click the header (where
“Name” and “Supplier” are displayed) and select
“Other...”.
(2) In the Advanced Settings dialog, check “Version” and
click “OK”. The version column appears. Check the
version of “ProDisc”.
Note
Sakura.SMI
Able to use clips with user-defined names
over FAM and FTP connections
Able to use clip lists with user-defined names
over FAM and FTP connections
Fuji.MXF
Note
Note