Sony XDCAM HD PDW-HD1500 - Manual (Page 137)

137
Troubleshooting
Ap
pend
ix
Alarms relating to audio and video signals
Duration of One Clip List
must be Less than 24 Hours. The total duration of the current clip list is greater than 24 hours.
This appears when the total duration of the current clip list exceeds the upper limit of 24 hours as
the result of adding or trimming sub clups.
No More Sub Clips can be
Added to the Clip List. The upper limit of sub clips in the current clip list has been reached.
This appears when the upper limit of 300 clips in a clip list has been reached as the result of
adding or trimming sub clips.
Sub Clip does not Exist. There are no sub clips in the current clip list.
This appears when an attempt is made to move, trim or delete sub clips or preset timecode.
Clip List does not Exist. There are no clip lists on the disc.
This appears when an attempt is made to execute a Delete Clip List operation when there are no
clip lists on the disc.
Move is Invalid. The sub clip cannot be moved.
This appear when an attempt is made to execute a Move Sub Clips operation when there are no
sub clip in the current clip list, or when there is only one sub clip.
Chapter does not Exist. The specified chapter has not been recorded.
This appears when an attempt is made to display a chapter when a chapter has not been
recorded for that clip.
Rec Start cannot be Deleted. The Rec Start essence mark cannot be deleted.
This appears when an attempt is made to delete a Rec Start with a Delete Shot Mark operation.
Delete Shot Mark can delete only Shot Mark1 and Shot Mark2 marks.
Rec Start cannot be Moved. Rec Start essence mark cannot be moved.This appears when an attempt is made to move a
Rec Start with a Move Shot Mark operation. Move Shot Mark can move only Shot Mark1 and
Shot Mark2 marks.
Clip is Locked. The clip is locked.
This appears when an attempt is made to delete a clip, set the clip thumbnail, or delete a shot
mark when the clip is locked.
All Clips are Locked. All clips are locked.
This appears when an attempt is made to execute a Lock All Clips operation when all clips are
already locked.
All Clips are Unlocked. All clips are unlocked.
This appears when an attempt is made to execute an Unlock All Clips operation when all clips
are already unlocked.
Command Disabled. This appears when an attempt is made to perform Format Disc operation while Disable “Format
Disc” is set to “Disable”.
A File with the Name you
Specified Already Exists.
Specify a Different Name. This appears when an attempt is made to set an existing clip name while changing the clip name
using Set Clip Name.
Set NAMING FORM to “free” This appears when an attempt is made to change the clip name using Set Clip Name even
though NAMING FORM is not set to “free” (see page 88).
“No Flash Drive” This appears when an attempt is made to select “USB Flash Drive” in the media selection
screen under Load Planning Metadata/Select Drive even though the USB memory is not
connected.
Alarm message in time
data display area Alarm message in video monitor screen Action
No INPUT!
a) INPUT VIDEO IS NOT DETECTED.
CHECK THE VIDEO INPUT MODE AND
SUPPLY A VIDEO SIGNAL TO VIDEO
INPUT. • Check the setting of V INPUT on Page P1 VIDEO of
the function menu (see page 43).
• Input an HDSDI signal.
EMPHASIS! a) INPUT AUDIO EMPHASIS IS NOT
SUPPORTED.
CHECK THE EMPHASIS OF THE AUDIO
INPUT SIGNAL. Check the emphasis of the audio input signal.
Alarm message in GUI
screen Description/action