SMC Networks TIGERSWITCH 10/100 - Manual (Page 200)

C
OMMAND
L
INE
I
NTERFACE
3-58
The snmp-server host command is used in conjunction with
the snmp-server enable traps command. Use the
snmp-server enable traps command to specify which SNMP
notifications are sent globally. For a host to receive
notifications, at least one snmp-server enable traps command
and the snmp-server host command for that host must be
enabled.
However, some notification types cannot be controlled with the
snmp-server enable traps command. For example, some
notification types are always enabled.
Example
Related Commands
snmp-server enable traps (3-58)
snmp-server enable traps
Use this command to enable this device to send Simple Network
Management Protocol traps or informs (SNMP notifications). Use
the no form to disable SNMP notifications.
Syntax
snmp-server enable traps [authentication | link-up-down]
no snmp-server enable traps [authentication |
link-up-down]
• authentication - Keyword to issue authentication failure
traps.
• link-up-down - Keyword to issue link-up or link-down
traps.
The link-up-down trap can only be enabled/disabled via the
CLI.
Console(config)#snmp-server host 10.1.19.23 batman version 1
Console(config)#