SMC Networks TIGERSWITCH 10/100 - Manual (Page 239)

I
NTERFACE
C
OMMANDS
3-97
switchport broadcast percent
Use this command to configure broadcast storm control. Use the
no form to disable broadcast storm control.
Syntax
switchport broadcast percent level
no switchport broadcast
level - Threshold level as a percentage of bandwidth.
(Range: 6 or 20 percent)
Default Setting
Enabled for all ports
Six percent of bandwidth
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When broadcast traffic exceeds the specified threshold, packets
above that threshold are dropped.
• This command can enable or disable broadcast storm control
for the selected interface.
Example
The following shows how to configure broadcast storm control at
20% on port 3:
Console(config)#interface ethernet 1/3
Console(config-if)#switchport broadcast percent 20
Console(config-if)#