SMC Networks TIGERSWITCH 10/100 - Manual (Page 210)

C
OMMAND
L
INE
I
NTERFACE
3-68
Line Commands
You can access the onboard configuration program by attaching a
VT100 compatible device to the server’s serial port. These
commands are used to set communication parameters for the serial
port or Telnet (i.e., a virtual terminal).
Command Function Mode Page
line Identifies a specific line for configuration and
starts the line configuration mode GC 3-69
login Enables password checking at login LC 3-70
password Specifies a password on a line LC 3-71
exec-timeout Sets the interval that the command
interpreter waits until user input is detected
LC 3-72
password-th
resh Sets the password intrusion threshold, which
limits the number of failed logon attempts LC 3-73
silent-time* Sets the amount of time the management
console is inaccessible after the number of
unsuccessful logon attempts exceeds the
threshold set by the password-thresh
command LC 3-74
databits* Sets the number of data bits per character
that are interpreted and generated by
hardware LC 3-75
parity* Defines the generation of a parity bit LC 3-76
speed* Sets the terminal baud rate LC 3-77
stopbits* Sets the number of the stop bits transmitted
per byte LC 3-78
show line Displays a terminal line's parameters NE,
PE 3-78
* These commands only apply to the serial port.