SMC Networks TIGERSWITCH 10/100 - Manual (Page 93)

VLAN C
ONFIGURATION
2-61
Adding Static Members to VLANs (VLAN Index)
Use the VLAN Static Table to configure port members for the
selected VLAN index. Assign ports as tagged if they are connected
to 802.1Q VLAN compliant devices, or untagged they are not
connected to any VLAN-aware devices. Or configure a port as
forbidden to prevent the switch from automatically adding it to a
VLAN via the GVRP protocol.
Notes: 1. You can also use the VLAN Static Membership by Port
page to configure VLAN groups based on the port
index. However, note that this configuration page can
only add ports to a VLAN as tagged members.
2. VLAN 1 is the default untagged VLAN containing all
ports on the switch, and can only be modified by first
reassigning the default port VLAN ID as described under
“Configuring VLAN Behavior for Interfaces” on page
2-65.
Command Attributes
• VLAN – ID of configured VLAN (1-4094, no leading zeroes).
• Name – Name of the VLAN (1 to 32 characters).
• Status – Shows if this VLAN is enabled or disabled.
- Enable: VLAN is operational.
- Disable: VLAN is suspended; i.e., does not pass packets.
• Port – Port identifier.
• Trunk – Trunk identifier.