SMC Networks TIGERSWITCH 10/100 - Manual (Page 230)

C
OMMAND
L
INE
I
NTERFACE
3-88
Example
This example displays the current status.
Interface Commands
These commands are used to display or set communication
parameters for an Ethernet port, aggregated link, or VLAN.
Console#show queue hol-prevention
HOL blocking prevention status: Disabled
Console#
Command Function Mode Page
interface Configures an interface type and enters
interface configuration mode GC 3-89
description Adds a description to an interface
configuration IC 3-90
speed-duplex Configures the speed and duplex operation
of a given interface when autonegotiation
is disabled
IC 3-90
negotiation Enables autonegotiation of a given
interface IC 3-92
capabilities Advertises the capabilities of a given
interface for use in autonegotiation IC 3-93
flowcontrol Enables flow control on a given interface IC 3-94
shutdown Disables an interface IC 3-96
switchport
broadcast
percent Configures broadcast storm control IC 3-97
clear counters Clears the statistics on the specified
interface
PE 3-98
show
interfaces
status Displays status for the specified interface NE,
PE 3-99