SMC Networks TIGERSWITCH 10/100 - Manual (Page 205)

IGMP S
NOOPING
C
OMMANDS
3-63
response-time. If the countdown finishes, and the client still
has not responded, then that client is considered to have left
the multicast group.
Example
The following shows how to configure the query count to 10:
Related Commands
ip igmp snooping query-max-response-time (3-63)
ip igmp snooping query-max-response-time
Use this command to configure the snooping report delay. Use the
no form of this command to restore the default.
Syntax
ip igmp snooping query-max-response-time seconds
no ip igmp snooping query-max-response-time
seconds - The report delay advertised in IGMP queries.
(Range: 5-30)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
• The switch must be using IGMPv2 for this command to take
effect.
• This command defines the time after a query, during which a
response is expected from a multicast client. If a querier has
sent a number of queries defined by the ip igmp snooping
Console(config)#ip igmp snooping query-count 10
Console(config)#