SMC Networks TIGERSWITCH 10/100 - Manual (Page 270)

C
OMMAND
L
INE
I
NTERFACE
3-128
switchport native vlan
Use this command to configure the PVID (i.e., default VLAN ID)
for a port. Use the no form to restore the default.
Syntax
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4094, no
leading zeroes)
Default Setting
VLAN 1
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• If an interface is not a member of VLAN 1 and you assign its
PVID to this VLAN, the interface will automatically be added to
VLAN 1 as an untagged member. For all other VLANs, an
interface must first be configured as an untagged member
before you can assign its PVID to that group.
• If acceptable frame types is set to all or switchport mode is set
to hybrid, the PVID will be inserted into all untagged frames
entering the ingress port.
Example
The following example shows how to set the PVID for port 1 to
VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#