SMC Networks TIGERSWITCH 10/100 - Manual (Page 26)

S
WITCH
M
ANAGEMENT
1-12
Trap Receivers
You can also specify SNMP stations that are to receive traps from
the switch.
To configure a trap receiver, complete the following steps:
1. From the Privileged Exec level global configuration mode
prompt, type “snmp-server host host-address
community-string,” where “host-address” is the IP address for
the trap receiver and “community-string” is the string
associated with that host. Press <Enter>.
2. In order to configure the switch to send SNMP notifications,
you must enter at least one snmp-server enable traps
command. Type “snmp-server enable traps type,” where “type”
is either authentication or link-up-down. Press <Enter>.
Saving Configuration Settings
Configuration commands only modify the running configuration
file and are not saved when the switch is rebooted. To save all
your configuration changes in nonvolatile storage, you must copy
the running configuration file to the start-up configuration file
using the “copy” command.
To save the current configuration settings, enter the following
command:
1. From the Privileged Exec mode prompt, type “copy
running-config startup-config” and press <Enter>.
Console(config)#snmp-server enable traps link-up-down
Console(config)#