Schneider Electric Processor Adapter - Manual (Page 92)

Assembling Momentum Components
92 870 USE 101 10 V.2
Disassembling a Processor Adapter from an I/O Base
Overview This section contains safety precautions and a procedure for disassembling a
Processor Adapter from an I/O base.
Tools Required A flat-head screw driver.
Procedure:
Disassembling
an Adapter from
an I/O Base Follow the steps in the table below to remove a Processor Adapter from an I/O
base.
Continued on next page
CAUTION
ELECTRICAL CIRCUITRY MAY BE EXPOSED
Before removing an adapter from the base, disconnect the wiring connectors. Be sure that
the I/O base is not under power when it does not have a Momentum adapter mounted on it.
Failure to observe this precaution can result in injury or equipment damage and will
void the product warranty.
Step Action
1 Choose a clean environment to disassemble the unit, in order to protect the
circuitry from contamination.
2 Be sure that the I/O base is not under power, by removing the terminal connectors
from the I/O base.