Kodak 2400DSV - Manual (Page 12)

Safety Precautions for Inspection and Service 1
5
3. Precautions for Working Environment
4. Precautions for Handling Batteries
5. Precautions for Laser Beam (Products Employing Laser Only)
.
• The product must be placed on a flat, level surface that is
stable and secure.
• Never place this product or its parts on an unsteady or
tilting workbench when servicing.
• Provide good ventilation at regular intervals if a service job
must be done in a confined space for a long period time.
• Avoid dusty locations and places exposed to oil mist or
steam.
• Avoid working positions that may block the ventilation port
of the product.
• Replace a rundown battery with the same type as specified
in the manufacturer’s parts manual.
• Before installing a new battery, make sure of the correct
polarity of the installation or the battery could burst.
• Dispose of used batteries according to the local regulations.
Never dispose of them at the user’s premises or attempt to
try to discharge one.
• Removing the cover marked with the following caution label
could lead to possible exposure to the laser beam, resulting
in eye damage or blindness. Be sure to unplug the power
cord before removing this cover.
• If removing this cover while the power is ON is unavoidable,
be sure to wear protective laser goggles that meet
specifications.
• Make sure that no one enters the room when the machine
is in this condition.
• When handling the laser unit, observe the “Precautions for
Handling Laser Equipment.
DANGER
Invisible laser radiation when open.
AVOID DIRECT EXPOSURE
TO BEAM
0947-7127-01
1144D270AA
1167P001AA