Kodak 2400DSV - Manual (Page 39)

3 General Information
32
13. Memory Input Key: To store one of the following functions into the memory
of the Scanner, first set one of the functions on Control
Panel and then press this button with the head of a pen
or other device. The next time the scanner is turned
ON, that function will appear as a default setting until a
new one is entered. (Maximum three kind of setting can
be memorized.)
1) Film Type
2) Print mode
3) Output Selection
4) Print image density
5) Exposure mode
6) Centering or Fit
7) Masking
8) Auto Skew Correction
9) Horizontal Area setting
10) Vertical Area setting
11) Electrical Zoom
12) Resolution
If you do not press the pinhole for at least 60 seconds
after a setting has been made with the Auto Reset func-
tion set to ON, the previous setting remains valid.
14. Clear/Stop Key: Press to clear the setting on the Multi-Print Display, re-
setting it to “1” or to stop a multi-print cycle.
15. Multi-Print Keys: This key is used to set the number of prints when print-
ing continuous, multiple pages.
The value of this setting increases by one (1, 2, 3...)
with every push of the key. (Maximum 19)
* PR mode only.
16. Start Key: Press to make a print (scan) of the image shown on the
Screen.