KORG Professional Engineer PA3 - Manual (Page 152)

150 Effects
Delay
i: Time Over? L, R
You can set the delay time up to 2,550msec. If the delay time
exceeds this limit, the error message “OVER!” appears in the dis-
play. Set the delay time parameters so that this message will not
appear. “Time Over?” is only a display parameter.
78: St.BPMAutoPanDly
(Stereo BPM Auto Panning Delay)
This stereo auto panning delay enables you to set the delay time
to match the song tempo.
l
Wet/Dry
-Wet, -
1:99...Dry...99:1
, Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 106
Amt –100...+100 Amount of modulation source
a
BPM
MIDI,
40.00...
300.00 MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Time Over? L ---, OVER!
Display the error message if the left
channel delay time exceeds the
upper limit
R ---, OVER!
Display the error message if the
right channel delay time exceeds
the upper limit
b
L Delay Base
Note
r...w
Selects the type of notes to specify
the left channel delay time
Times x1...x32
Sets the number of notes to specify
the left channel delay time
Feedback –100...+100
Sets the feedback amount for the
left channel
c
R Delay Base
Note
r...w
Selects the type of notes to specify
the right channel delay time
Times x1...x32
Sets the number of notes to specify
the right channel delay time
Feedback –100...+100
Sets the feedback amount for the
right channel
d
High Damp [%] 0...100
Sets the damping amount in the
high range
Low Damp [%] 0...100
Sets the damping amount in the low
range
e
LFO Waveform Triangle, Sine Selects the LFO Waveform
Shape –100...+100
Changes the curvature of the LFO
Waveform
LFO Phase –180...+180
Sets the LFO phase difference
between the left and right
f
Panning Freq
[Hz]
0.02...20.00 Sets the panning speed
g
MIDI Sync Off, On
When this is on, the pan LFO speed
is set by BPM, Base Note, and Times,
instead of Frequency
BPM
MIDI,
40.00...
300.00 MIDI syncs to the system tempo; 40–
300 sets the tempo manually for this
individual effect
Base Note r...w
Selects the type of notes to specify
the delay time for the panning
speed
Times x1...x32
Sets the number of notes to specify
the delay time for the panning
speed
h
Panning Depth 0...100 Sets the panning width
Src Off...Tempo
Selects the modulation source for
the panning width
Amt –100...+100
Set the modulation amount of the
panning width
i
Wet/Dry
Dry, 1:99...99:1,
Wet Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 106
Amt –100...+100 Amount of modulation source
Tempo
BPM
BPM Base Note x Times
Base Note x Times
Left
Right
FX Amt
FX Amt
Stereo In - Stereo Out
LFO Phase
LFO Shape
Pan
Pan
LFO: Tri / Sin
Depth
Delay
Delay
High Damp Low Damp
High Damp Low Damp
Feedback