KORG Professional Engineer PA3 - Manual (Page 7)

5 Style Record mode
Exit by saving or deleting changes
Advanced
Note: While in Record mode, the footswitch and EC5 pedals are
disabled. On the contrary, volume/expression-type pedals can be
used.
Exit by saving or deleting changes
When finished editing, you can save your Style or Pad in mem-
ory, or abort any change.
• To save changes, select the “Write Style” command from the
page menu (see “Write Style dialog box” on page 31).
• To abort all changes, select the “Exit from Record” command
from the page menu, or press the RECORD button, to exit from
record and return to the main page of the Style Record mode.
Hint: Save often while recording, to avoid accidentally losing your
changes to the Style.
Listening to the Style while in Edit mode
While you are in Style/Pad Record mode, you can listen to the
selected Chord Variation or to the whole Style or Pad, depending
on the page you are in.
To select a Chord Variation, go to the Main page of the Record/
Edit mode (see “Element (Style Element)” and “Chord Var
(Chord Variation)” on page 6).
• When you are in the Main, Event Edit, Quantize, Trans-
pose, Velocity, or Delete pages, you can listen to the
selected Chord Variation. Press START/STOP to check
how it works. Press START/STOP again to stop the play-
back.
• When you are in the Sounds/Expression, Keyboard Range,
Chord Table, Trigger/Tension, Delete All, Copy, Style/Pad
Element Controls or Style/Pad Control pages, you can lis-
ten to the whole Style or Pad. Press START/STOP and play
some chords to do your tests. Select any Style/Pad Element
using the control panel buttons (VARIATION 1-4, INTRO
1-3, FILL 1-4, BREAK, ENDING 1-3). Press START/STOP
again to stop the playback.
• When you are in the Guitar Mode page, you can listen to
the pattern you are programming, played in the selected
Key.
Note: While in Style Record mode, the Fingered 3 Chord Recogni-
tion mode is automatically selected.
List of recorded events
The Style/Pad Record mode filters out some events that may
cause wrong operation of the Style or Pad. Here are the recorded
events, and the most important filtered-out events.
Note: Some Control Change messages cannot be recorded directly
by using Pa3X integrated controls (like the Ribbon Controller).
All allowed controllers can be assigned to an Assignable Pedal/
Slider/Switch.
MIDI Control Change messaged inserted by using a software on
an external computer are imported when using the import func-
tion (“Import: Import SMF” on page 28).
Some controllers are reset at the end of the pattern.
Control function CC#
Allowed
Note On
RX Noise On
Pitch Bend
Channel After Touch
Modulation 1
Breath 2
Pan 10
Expression 11
CC#12 12
CC#13 13
Damper (Hold 1) 64
Filter Resonance (Harmonic Content) 71
Low Pass Filter Cutoff (Brightness) 74
CC#80 (General Purpose #5) 80
CC#81 (General Purpose #6) 81
CC#82 (General Purpose #7) 82