KORG Professional Engineer PA3 - Manual (Page 173)

171 Effects
Double Size
Advanced
Double Size
Double-size effects take two processing units, therefore “steal-
ing” one unit to the following FX processors.
120: St. Mltband Limiter
(Stereo Mltband Limiter)
This is a stereo multiband limiter.
121: PianoBody/Damper
(PianoBody/Damper Simulation)
This effect simulates the resonance of the piano sound board
caused by the string vibration, and also simulates the resonance
of other strings that are not being played when you press the
damper pedal. It will create a very realistic sound when applied
to acoustic piano sounds.
a: Sound Board Depth
This parameter sets the intensity of resonance of the piano
sound board.
b: Damper Depth
b: Src
This parameter sets the resonance intensity of the other strings
created when the damper pedal is pressed. The “Src” parameter
selects the modulation source from which the damper effect is
applied. Usually, select Damper #64 Pdl (Damper pedal).
The effect is off when a value for the modulation source specified for
the “Src” parameter is 63 or smaller, and the effect is on when the
value is 64 or higher.
c: Tone
d: Mid Shape
These parameters control the tonal quality of the effect sound.
e: Tune
Since this effect simulates the resonance of the strings, the sound
varies depending on the pitch. If you have changed tuning using
the “Master Tuning” (Global > General Controls > Basic), adjust
this parameter value.
a Ratio
1.0 : 1...
50.0 : 1, Inf : 1
Sets the signal compression ratio
b Threshold [dB] –40...0
Sets the level above which the
compressor is applied
c Attack 1...100 Sets the attack time
d Release 1...100 Sets the release time
e Low Offset [dB] –40...0
Sets the low range gain of trigger
signal
f Mid Offset [dB] –40...0
Sets the mid range gain of trigger
signal
g
High Offset
[dB]
–40...0
Sets the high range gain of trigger
signal
h
Gain Adjust
[dB] –Inf,
–38...+24
Sets the output gain
Src Off...Tempo
Selects the modulation source for
the output gain
Amt –63...+63
Sets the modulation amount of the
output gain
i
Wet/Dry
Dry, 1:99...99:1,
Wet Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 106
Amt –100...+100 Amount of modulation source
Left
Right
FX Amt
FX Amt
Stereo In - Stereo Out
Gain Adjust
Limiter
Limiter
Limiter
Envelope - Control
Envelope - Control
Envelope - Control
Gain Adjust
Limiter
Limiter
Low
Mid
High
Envelope - Control
Envelope - Control
Envelope - Control
Low
Mid
High
Offset
Band-Pass Filters
Limiter
a
Sound Board
Depth
0...100
Sets the intensity of resonance of
the sound board
b
Damper Depth 0...100
Sets the intensity of the string
resonance created when the
damper pedal is pressed
Src Off...Tempo
Selects the modulation source of
damper effect
c Tone 1...100 Sets tonal quality of effect sound
d Mid Shape 0...36 Sets the mid range of tonal quality
e Tune –50...+50 Fine tuning
f
Wet/Dry
Dry, 1:99...99:1,
Wet Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 106
Amt –100...+100 Amount of modulation source
Left
Right
FX Amt
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
D -mod
Piano
Body/Damper
Simulation
Damper
+