Lanier CW2200SP - Manual (Page 184)

Message Causes Solutions
"Hardware Problem: USB" An error has occurred in the
USB interface. Turn off the main power switch, and
then back on again. If the message
appears again, contact your service
representative.
"Hardware Problem:
Wireless Card" The wireless LAN board can
be accessed, but an error was
detected. Turn off the main power switch, and
then confirm the wireless LAN board is
inserted correctly. And then, turn on
the main power switch again. If the
message appears again, contact your
service representative.
"Load following paper in n.
To cancel job, press [Job
Reset]."
(A figure is placed at n.) • The printer driver settings
are incorrect.
• The paper input location
does not contain paper
of the size selected in the
printer driver.
Check that the printer driver settings
are correct, and then load paper of
the size selected in the printer driver
into the paper input location. For
details about how to change the
paper size, see "Changing the Paper
Size", Paper Specifications and
Adding Paper .
"Paper size and type are
mismatched. Select another
tray from the following and
press [Continue]. To cancel
job, press [Job Reset].
Paper size and type can
also be changed in User
Tools." • The printer driver settings
are incorrect.
• The paper input location
does not contain paper
of the size or type
selected in the printer
driver.
• Check that the printer driver
settings are correct, and then
load paper of the size selected in
the printer driver into the paper
input location. For details about
how to change the paper size,
see "Changing the Paper Size",
Paper Specifications and Adding
Paper .
• Select the paper input location
manually to continue printing, or
cancel a print job. For details
about how to select the paper
input location manually, or
cancel a print job, see "If an
Error Occurs with the Specified
Paper Size and Type", Print .
9. Troubleshooting
182