Lanier CW2200SP - Manual (Page 202)

Message Causes Solutions
"The entered file name
contains invalid character(s).
Enter the file name again
using any of the following 1
byte characters. " 0 to 9 ", "
A to Z ", " a to z ", " . - _"" The file name contains a
character that cannot be
used. Check the file name set at the time of
scanning. For details about characters
that can be used in file names, see
"Specifying the File Name", Scan .
"The entered file name
contains invalid character(s).
Enter the file name again
using any of the following 1
byte characters. " 0 to 9 ", "
A to Z ", " a to z ", " . - _"" The file name contains a
character that cannot be
used. Check the file name specified at the
time of scanning. The file name
specified in the Sending Scan Files to
Folders function cannot contain the
following characters:
\ / : * ? " < > |
The file name cannot start or end with a
period ".".
"The selected file(s)
contained file(s) without
access privileges. Only
file(s) with access privileges
will be deleted." You have tried to delete files
without the authority to do
so. To check your access permission for
stored documents, or to delete a
document you do not have permission
to delete, see Security Guide .
"Transmission has failed.
Insufficient memory in the
destination hard disk. To
check the current status,
press [Scanned Files
Status]." Transmission has failed.
There was not enough free
space on the hard disk of the
SMTP server, FTP server, or
client computer at the
destination. Allocate sufficient space.
"Transmission has failed. To
check the current status,
press [Scanned Files
Status]." While a file was being sent,
a network error occurred
and the file could not be sent
correctly. If the same message appears again
after scanning again, the cause could
be a mixed network. For details about
network error, contact your
administrator.
"Updating the destination list
has failed. Try again?" A network error has
occurred. Check whether the server is connected.
9. Troubleshooting
200