Lochinvar TISUN SCH-I-O - Manual (Page 16)

SCH Collectors Installation & Operation Manual
16
SCH Collectors Installation & Operation Manual
Flat tile hook
#SRM20005
The flat tile hook is only used for parallel installation on
plain tiled roofs (generally steep roofs with a pitch of over
30°), the hooked ends are hung over the roof battens and
screwed in place, an inclined collector installation is not
possible here.
Figure 3-10 Kit #SRM20005 - Flat Tile Hook Kit
Components
Unpacking and checking parts
When unpacking the system, check the model names of
the components of each system and check to be sure you
have the correct number of parts (see FIG. 3-10).
FLAT TILE HOOK (1X)
HEX NUT (M8) (1X)
HEX BOLT (M8) (1X)
WOOD SCREW (1X)
NAIL (3X)
WASHER (M8) (1X)
SQUARE DISK (1X)
METAL SHEET (1X)
3
Roof Attachment Installation
11. Slide the square disk onto the hex bolt (see FIG. 3-8).
12. Install the hex bolt with square disk attached into the opening
of the rafter anchor as shown in FIG. 3-8.
Note: Do not tighten hex bolt until ready to install on the collector
substructure.
13. Thread the hex nut (M8) and washer (M8) onto the bottom of
the hex bolt installed in Step 12.
14. Repeat Steps 4 - 13 until installation is complete.
15. Replace tiles removed in Step 4.
Install hex bolt onto collector substructure (reference Section 4 -
Collector Installation)
Figure 3-8 Install Rafter Anchor
HEX BOLT
COLLECTOR SUBSTRUCTURE
RAFTER ANCHOR
SPACER PLATE
(IF NECESSARY)
INSTALL WASHER
AND WOOD SCREW
Figure 3-9 Grind Tile (if necessary)
IF NECESSARY, GRIND
THE TILE FOR A BETTER
FIT