Lochinvar TISUN SCH-I-O - Manual (Page 29)

SCH Collectors Installation & Operation Manual
SCH parallel mounting instructions
4
Collector Installation
(continued)
1. Install roof attachments (see the Roof Attachment
Section on pages 13 - 27 of this manual).
2. Install the horizontal bar(s) (FIG.'s 4-2A and 4-2B)
using the square disk, hex bolt, and washers provided
in the kit.
Figure 4-3 Install Z-Hooks
2 x / per collector 3 x / per collector
SCH065 SCH090, 110, AND 130
INSTALL Z-HOOKS
4. Ensure lifting rings are installed and properly spaced as
per FIG. 4-4.
Figure 4-4 Lifting Rings
< 30°
6.5 ft.
< 30°
6.5 ft.
< 30°
6.5 ft.
< 30°
8.5 ft.
5. Position the collector onto the substructure and hanger
brackets (FIG. 4-5).
Figure 4-5 Position Collector On Substructure
POSITION PANEL ONTO
SUBSTRUCTURE
Z-HOOK
6. Secure the collector to the Z-hook(s) using the
square disk and hex bolt provided in the kit (FIG. 4-6).
SCH Collectors Installation & Operation Manual
Figure 4-2A Install Horizontal Bars
ENDS OF HORIZONTAL BARS
MUST BE PARALLEL TO ENSURE
PROPER COLLECTOR
ORIENTATION
a a
a
a
=
=
=
55 - 63 in.
a = 2 - 10 in.
x
x
29
Figure 4-2B Spacing
Only loosen the crane connection when
the collectors are completely fixed to the
substructure.
ƽ WARNING
3. Install the Z-hooks per FIG. 4-3 using the
specified number of brackets.