Lochinvar TISUN SCH-I-O - Manual (Page 23)

SCH Collectors Installation & Operation Manual
23
3
Roof Attachment Installation
(continued)
Figure 3-27 Drill Holes and Attach Flange Plate
COLLECTOR
SUBSTRUCTURE
HEX BOLT
SQUARE DISK
USE THE SMALLER SCREWS
IN THE PERIMETER OF THE
FLANGE PLATE
PRE-DRILL FOUR (4) 6 MM
HOLES - USE THE LARGER
SCREWS TO SECURE THE
FLANGE PLATE
8. Slide the square disk onto the hex bolt (see FIG. 3-27).
9. Install the hex bolt with square disk attached into the
opening of the flange plate as shown in FIG. 3-27.
Note: Do not tighten hex bolt until ready to install on the
collector substructure.
10. Thread the hex nut (M8) and washer (M8) onto the bottom
of the hex bolt installed in Step 9.
11. Repeat Steps 4 - 10 until installation is complete.
Install hex bolt onto collector substructure (reference Section 4 -
Collector Installation)
Corrugated metal roof attachment
#SRM20013
The corrugated metal roof attachment is used for parallel
and inclined mounting on profiled or corrugated sheet metal
roofs. The console is mounted above the mounting screws
of the profiled or corrugated sheet metal. The two sealing
screws are first screwed onto the underlying mounting
screw of the sheet. The sealing is done before the console is
mounted using the sealing pads supplied. The sections are
fixed to the section connectors on the console.
• The console must be ordered to
fit the relevant profiled or
corrugated sheet metal.
• The mounting screws supplied
with the console must be
appropriate in type and length for
the particular roof construction.
ƽ CAUTION
Figure 3-29 Kit #SRM20013 - Corrugated Metal Roof
Attachment Kit Components
HEX NUT (M10) (1X)
STUD (M10) (1X)
PROFILE CONNECTOR (1X)
HEX BOLT (M8) (1X)
WASHER (M10) (2X)
HEX NUT (M10) (2X)
WASHER (M8) (1X)
Unpacking and checking parts
When unpacking the system, check the model names of the
components of each system and check to be sure you have the
correct number of parts (see FIG. 3-29).
SCH Collectors Installation & Operation Manual
Figure 3-28 Cover Flange Plate with Roofing Material
COVER FLANGE PLATE WITH
ROOFING MATERIAL, SEALING
IT TO THE ROOF
2”
4.7 mm 4.7”
6”
> 4.7”