Lochinvar TISUN SCH-I-O - Manual (Page 9)

SCH Collectors Installation & Operation Manual
2
Location
(continued)
Handling and storing
Figure 2-6 Crane Transportation Connection Points and Positioning
< 30°
6.5 ft.
< 30°
6.5 ft.
< 30°
6.5 ft.
< 30°
8.5 ft.
What to avoid
• Collectors are to be located such that
eventual sliding of snow and ice does
not endanger any person.
ƽ WARNING
ƽ CAUTION
NOTICE
• Installation of LOCHINVAR/TiSun
SCH collectors is only allowed for
professional staff.
• Local instructions, laws and standards
are to be kept.
• Collectors are to be located so
falling of snow and ice does not
endanger any person or property.
• Use personal protection equipment
(helmet, belt, security shoes) when on
the roof.
• Secure tools and materials against
falls.
•
It is forbidden to stand under
hanging load.
ƽ WARNING
• Danger area has to be closed.
• Put ladders up properly and check
stability.
ƽ CAUTION
• Check the under roof construction on
the building before installation.
NOTICE
• Only loosen the crane connection
when the collectors are completely
fixed to the substructure.
• Pay special attention to roof-work
near an electric grid. If need be, the
constructor must take security
precautions such as isolation,
covering,
etc.
• Inspect the roof surface in the area of
the installation for cracks, water
leakage, and roofing material quality
and uniformity. This is especially
important if the roof is more than 10
years old.
• Inspect the roof for sags and other
abnormalities. A sag or deep
depression in the roof may indicate a
structural weakness in the support
system that may require correction.
• Check that all rafters, trusses and
other materials are in good condition.
• See FIG. 2-6 for crane transportation
connection points and positioning.
• Avoid rotating movements of the
load through wind. Secure load
before lifting.
• Only move collectors on the given
fixing loops.
ƽ WARNING
9