Pioneer RM V2550BU - Manual (Page 120)

110
ADJUSTMENTS
(4) White balance adjustment flowchart
When adjusting the multi projection unit Initial setting
Multi on
ABL switching setting (Refer to page 111 (5) White balance adjustment)
1 White balance adjustment (COMBI OFF)
Black level adjustment (white 10%)
HIGH, LOW LIGHT check (white 0% to 100%)
START
LOW LIGHT adjustment (white 20%)
HIGH LIGHT adjustment (white 50%)
ABL GAIN adjustment (White 100%) (Fix to maximum normally)
NG
OK
ABL check (white 0% to 100%)
LINEAR WHITE adjustment (Cross hatch) (Fix to maximum normally)
NG
Re-HIGH LIGHT adjustment (White 80%, 50%)
Re-LOW LIGHT adjustment (White 20%)
HIGH, LOW LIGHT check (White 0% to 100%)
ABL LEVEL adjustment (White 100%)
ABL GAIN adjustment (White 100%)
Rough adjustment end
Moving image check
Moving image adjustment
OK
2 ABL link and LINEAR WHITE flesh color adjustment (COMBI ON)
YES
NO Is INPUT
Function
RGB?
Re-LINEAR WHITE adjustment (Cross hatch)
OK
COLOR adjustment
TINT adjustment
SHARPNESS adjustment
NG
COLOR ,TINT
SHRPNESS check OK
NG
Fine adjustment input
When W/B is incorrect
End
(Note)
After completing adjustments, if the lumi-
nance of the multi-screen has dropped, or
the luminance is not consistent, change
the setting of the ABL switch and repeat
from step 2 .
ABL LEVEL adjustment (White 100%)
HIGH, LOW Light check (white 0% to 100%)