Pioneer RM V2550BU - Manual (Page 161)

151
PRECAUTIONS
6. TROUBLESHOOTING
Check once again before assuming the set is malfunctioning. The problem may be due to inadequate mainte-
nance, erroneous operation, etc.
If the problem persists after the following checks have been made, contact a dealer.
Notes on the input signal
The video may not be displayed normally if any of the following signals is input.
¶ VCR signal obtained after repeated dubbing (copies).
¶ VCR or DVD signal containing copy guard signal.
¶ Other signal than the standard NTSC signal.
Notes on the input images
1. Colored characters or characters on color
background may be hard to read due to color
blur. (When displaying characters, it is recom-
mended to use those without colors or display
them on a background without colors.)
2. When the image contains areas with fine lines,
the horizontal lines may become hard to view
due to flickering.
Note on genlocking
The system does not incorporate the genlocking
function. This means that the signal output from
the system is not synchronized with the signal
input to it.
Note on screen burns
When the system has displayed a still image, re-
sidual images (screen burns) may remain on the
screens.
Treatment
¶ Insert the power plug completely
into the outlet.
¶ Press the power switch to ON.
¶ Insert the cable properly into the
jack.
¶ Connect the cable properly.
¶ Use another cable that is not defec-
tive.
¶ Re-insert the option board prop-
erly.
¶ Set the INPUT switch properly and
press the reset button.
¶ Set the MODE switch properly and
press the reset button.
¶ Set it properly. (See the caution on
the demonstration pattern setting
on page 169.)
¶ Adjust the position, etc. of the light
source.
Possible Causes
¶ The power cord is unplugged.
¶ The power switch is set to OFF.
¶ The video input cable is unplugged
from the video input.
¶ The video cable is plugged into a
wrong jack.
¶ The cable is disconnected or other-
wise defective.
¶ The option board is inserted in-
completely.
¶ The INPUT switch is set improp-
erly.
¶ The MODE switch is set improp-
erly.
¶ The demonstration pattern is set
erroneously.
¶ The joints reflect external light.
Symptom/Equipment
Power cannot be turned
on./All
Video is not displayed./All
Video is not displayed.
/Multi-video processor
The joints are glossy
/Multi-projection units