Pioneer RM V2550BU - Manual (Page 63)

53
INSTALLATION AND ASSEMBLY
[Fig. 3-4-19]
[3] Fix the cabinets using bolts. [Fig. 3-4-2]
Front: M8x30 x 2 (provided with each stand)
Rear: M8x60 x 2 (provided with each stand)
[4] Align the left and right cabinets. If the following conditions are not satisfied, adjust using the adjusters on
the stands.
(Front/rear):
Line up the wood surfaces of the front of the left and right cabinets. [Fig. 3-4-3]
(Top/bottom): Align the height of the bottom plates on the front of the left and right cabinets. [Fig. 3-4-4]
(Inclination): Reduce any clearance between the left and right cabinets to below 3 mm. [Fig. 3-4-5]
Flush
Left/right symmetrical
2 9-screen system assembly (using the RMA-V5020/WL)
— Please refer to the section on 4-screen system assembly for cautionary notes.—
[1] Place the cabinet on each stand. (3 cabinets)
NOTE) Always carry each cabinet with more than one person.
[2] Adjust the positioning of the cabinets. [Fig. 3-4-19]
Align the front and rear of each cabinet/stand with respect to the L-shaped brackets on the stand.
Align the left and right of each cabinet/stand so as to make flush the side surfaces of the cabinet/stand on the
side which comes in contact with another cabinet/stand pair.
Place the central cabinet/stand in a symmetrical position with respect to the other pairs of cabinet/stand.
Bolts (M8x30)
Flush