Pioneer RM V2550BU - Manual (Page 167)

157
MVP MANUAL
5. MVP VIDEO OUTPUT MODES
¶ The video output formats set by the mode switches are as shown in the following table.
(At shipment, the mode switch value is set to “8”.)
* The settings shown below use the RMD-V3104U as an example.
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
NTSC
PAL
NTSC
PAL
VBS, Y/C
RGB
RGB
VBS, Y/C
RGB
RGB
Standard speed
Double speed
Standard speed
Double speed
Standard speed
Double speed
Standard speed
Double speed
OFF
OFF
ON
ON
Reserved
Reserved
Mode switch No. Bus format Output format Sync signal frequency Dropout reduction function
Reserved
Reserved
¶ Bus format : NTSC ..................... NTSC digital signal transmission method.
¶ Bus format : PAL ........................ PAL digital signal transmission method.
¶ Output format : VBS (VIDEO signal), Can be switched between Y/C and RGB.
However, VBS and Y/C can only be used for the standard speeds.
¶ Sync signal frequency : Standard speed .... Horizontal 15.734 kHz, vertical 59.94 Hz interlace (NTSC)
Horizontal 15.625 kHz, vertical 50.00 Hz interlace (PAL)
: Double speed ........ Horizontal 31.469 kHz, vertical 59.94 Hz non-interlace (NTSC)
Horizontal 31.250 kHz, vertical 50.00 Hz non-interlace (PAL)
¶ Dropout reduction function: Function for alleviating dropout due to the scanning line structure particular to
multi vision systems
NOTE:
With the RMD-V2550BU, only standard speed input is possible. Double speed signals can not be displayed.