Pioneer RM V2550BU - Manual (Page 169)

159
MVP MANUAL
7. PICTURE FRAME ADJUSTMENT PROCEDURES
Adjust the MVP picture frame as follows.
(1) Connect the RS-232C cable to the MVP panel.
(Refer to (P.153) “Connection with MVP external computer”.)
(2) Initialize the picture frame data in RAM.
ex. &L0 (Refer to &L command.)
(3) Set to the magnified screen to be adjusted.
ex. M11C22 (Refer to the M command, @ command.)
(@9 )
(4) Perform coarse adjustment of the picture frame.
ex. &P21 ++–– (Refer to the &P command.)
(5) Perform fine adjustment of the picture frame.
ex. &G0 LLRU (Refer to the &G command.)
(6) Repeat steps (4) and (5) for every position on the screen.
(7) Save the adjustment data in the EEPROM.
ex. &W1 (Refer to the &W command.)
1. Command reference
(1) To shift to the operation mode [! command]
Input: !
Explanation: By executing this command when the power is on, various commands can be executed.
(2) To set different screens for adjusting convergence [DFFC command]
Input: DFFC
Explanation: • By executing this command, the V IN input image will be displayed on a single 1x1 display.
• Use the crosshatch, etc. for V IN input images.
• For convergence adjustment, refer to the MPJ’s adjustment items.
(Returning to 4-screen enlarged display)
• The V IN input image is set to 4-screen enlarged display by @9 . (For the @ commands, refer to
page 163.)