Pioneer RM V2550BU - Manual (Page 95)

85
ADJUSTMENTS
Multii projection
unit
Computer
Multii projection
unit Multii projection
unit Multii projection
unit
ID=01 ID=02 ID=04 ID=03
**AJY
01IDS
**AJY
02IDS
**AJY
03IDS
**AJY
04IDS
<Assigning IDs from a computer>
Command: IDC (ID Clear) Clear assigned ID
IDS (ID Set) Assign ID
The IDS command is only valid when no ID is assigned, and is value from the unit closest to the
computer (remote control unit).
Example: With a 4-screen system (when assigning ID numbers for the first time from a computer)
ID numbers can be assigned to all the units by sending commands in this order. However, the ABL linking
cables must also be connected as shown above.
The characters that can be used for ID numbers are numbers 0 to 9, letters A to F (not case sensitive) and *.
The * (asterisk) can be used as follows:
**IDC : Clears all the ID numbers assigned to the units.
*0AJY : Sets the adjustment mode only for units with “0” as the second digit.
3*IN1 : Sets the input function to VIDEO only for units with “3” as the first digit.