Perle Systems RIO 5500036-17 - Manual (Page 56)

RIO Remote I/O System User Guide
Installing RIO under SCO OpenServer 5 and SCO OpenServer 6
Page 56
Chapter 2 Installing hardware and software
The Enter Image Directory window is now displayed.
9. In the Enter Image Directory window, enter the following in the Image directory field;
/mnt/drivers/rio/openserver/x.y.z , where x.y.z is the version number of the driver for
SCO OpenServer 5.
/mnt/drivers/rio/openserver6/x.y.z , where x.y.z is the version number of the driver for
SCO OpenServer 6.
10.In the Enter Image Directory window, click on OK .
The Install Selection window is now displayed.
11.In the Install Selection window, click on the Install button.
If you are upgrading your current Perle RIO device driver, a pop-up window is now
displayed as shown in the next picture.