Perle Systems RIO 5500036-17 User Manual
Page 80
RIO Remote I/O System User Guide
Installing RIO under SCO UnixWare
Page 80
Chapter 2 Installing hardware and software
3. In the Software Device Driver selections menu, click on the
Communications Cards
option and press the
Enter
key.
The Software Device Drivers window is now displayed
4. In the Software Device Drivers window, select the RIO driver (hint use the arrow keys to
move the cursor) and then press the
F5
key to add the new host card.
The New Hardware Configuration window is now displayed.
5. In the New Hardware Configuration window, set the parameters listed in the next table to
the values indicated.
Note
The
MemStart
and
MemEnd
values you set here must correspond to the values
set on the host card as detailed in
.
The
IRQ level
should be an IRQ that is not already in use by the system.