Pitney Bowes DM230L - Manual (Page 108)

SV61891 Rev. A 6-5
DM230L, DM330L, DM350L Operating Guide
5. Clean the brush in plain water, and rinse thoroughly.
6. Position the brush as shown above so its bottom edge is under the
mounting tabs.
7. Slide the brush back toward the rear of the moistener.
3. Place the wick in the holder.
4. Reinstall the wick and holder assembly.
Remove the Holder and Wick (DM230L/DM330L)
Wick
Holder
1. Remove the holder and wick from
the moistener as shown here.
2. Clean the wick in plain water, and
rinse thoroughly.
1. Line up the yellow tab with the
yellow slot.
2. Slide the moistener tank into
position on the mailing machine
base until the release lever
snaps into position. See the
figure at right.
3. Resume operation.
Reinstall the Moistener Tank (DM230L/DM330L)
Removing and
Cleaning the
DM230L/DM330L
continued…